Title

Ask and Answer

Can the wire be welded directly to the PCB circuit board without a joint?

1113 0 May 22.2019, 10:43:00

The actual fixed PCB space is limited (the PCB is fixed inside the equipment), and the network cable needs to be led to the outside. At present, the RJ45 seat does not want to be placed on the PCB, because the network cable takes up too much space after the crystal head is plugged in. Therefore, I would like to use connectors or terminals to replace the RJ45 seat (after inserting the network cable to the circuit board), or the network cable is directly welded to the PCB, would you like to ask if there is any experience in this area can be exchanged, is this feasible? Or if there are any good suggestions and solutions that can be used for reference. Thank you!

What should be paid attention to when stacking impedance in PCB design?

892 0 May 22.2019, 10:35:36

What should be paid attention to when stacking impedance in PCB design?I am now to make a pcb design,anyone can help me ?

What is the full overlap of punches on the pin? How to solve this problem?PCB project

1257 0 May 22.2019, 10:34:33

Punch holes in the middle of the chip pin all overlap, and then want one to move away, is not set up?

Hot Label

pcb fabrication electronic engineer PCB PCB design PCB assembly